![]() Otherwise, you will get a password error and the picture will not show up. If not, use the respective scanning tool to find out the IP address of your camera.ĭo not click One- touch Adding unless the cameras’ passwords are the same with the NVR password or the password of the camera is 12345. This step assumes that you already know the IP address of your camera and the credentials. Then type in the IP camera’s address, its username and its password. Login directly to your NVR and then go to Camera Management > Camera > IP Camera, select any channel and click Edit. Basically, the camera and the NVR should be on the same network. Connect your Hikvision IP camera to the PoE port of the (external) switch. How to add an IP camera to NVR using Manual mode Plug-and-Play mode can only be used when the camera is added directly to the built-in POE switch of an NVR. ![]() When using the Plug-and-Play mode, make sure the password of the camera is the same with the Hikvision NVR, or you could set the password of the camera to 12345 (and it will still work, even if the password for the NVR is different). A camera can be added into a Hikvision NVR thru the network (in this case Manual mode) or directly into the recorder (if the NVR has a built-in PoE switch). This article will show you how to add a PoE IP camera to a Hikvision surveillance system (NVR).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |